Blog / Ferguson / TE20 TEA20 TED20 Difference, and the TEF20: What Changes in the Body Panels
Ferguson

TE20 TEA20 TED20 Difference, and the TEF20: What Changes in the Body Panels

November 11, 2026 · AJVA Motors
Ferguson TE20 Body Parts Ferguson TE20 bonnet kits and body panels, made and exported by Ajva Motors.
View Catalog →

The TE20 TEA20 TED20 difference is the engine, not the body. At first, the TE20 had a Continental petrol engine. Then the TEA20 had a Standard petrol engine, the TED20 ran on vaporising oil and the TEF20 was the diesel. Most tinwork is shared across the range. The changes show at the fuel tank, the dash, the batteries and the front T-bar.

This guide is for restorers, dealers and workshops who buy Ferguson TE20 tinwork, the bonnet, grille, mudguards (fenders in the USA) and footplates. First it explains the Ferguson TE20 model codes. Then it shows how to read your tractor, and which body panels you need to check for each version.

Last updated: 11 November 2026

Ferguson TE20 model codes: what the letters mean

Every TE20 is a “Tractor England”. According to the Wikipedia entry for the Ferguson TE20, 517,651 of all models were built at Banner Lane, Coventry. The American TO20 and TO30, “Tractor Overseas”, were built in Detroit and are a separate family. After TE, the third letter marks the engine, the fuel and the track width. The table lists the codes a UK or Irish buyer meets most often.

CodeEngine and fuelBuiltNotes
TE20Continental Z120, petrol1946 to 1948The first tractors, before the Standard engine
TEA20Standard, petrol1947 to 1956The standard width petrol tractor
TEC20Standard 20S, petrol1948 to 1956Narrow version of the TEA20
TED20Standard 20S, TVO1949 to 1956Starts on petrol, runs on tractor vaporising oil
TEE20TVO1949 to 1956Narrow version of the TED20
TEF20Standard diesel1951 to 1956The diesel tractor
TEH20, TEJ20Lamp oil1950 to 1956Standard and narrow
TEK20, TEL20, TEM20Petrol, TVO, lamp oil1952 to 1956Vineyard versions
Ferguson TE20 model codes, from the Wikipedia production table. Industrial versions (TEP to TET) are left out.

Note that sources differ by a year on the first TE20: Anglo Agriparts gives 1947 to 1948 in its TE20 and TEF20 serial number tables. For body panels this does not matter, because the codes describe the engine.

How to spot the TE20 TEA20 TED20 difference on your tractor

Start with the serial plate. Anglo Agriparts says it sits at varying positions on the instrument console, depending on the model. The letters before the number give the code: TEA, TED or TEF. However, seventy years of repairs mean that parts get swapped, so check the plate against what you see on the tractor.

  • TED20: the Ferguson Club’s history of the little grey Fergie lists dual fuel tanks under the hinged bonnet, a three way fuel tap, an aluminium heat shield over the inlet manifold, and a water temperature gauge on the dash.
  • TEF20: the same source describes a pair of six volt batteries, one on each side of the driver’s seat, and a vertical exhaust. Anglo Agriparts gives the engine as the Standard 20C diesel.
  • TEA20: a single petrol tank, none of the TED20 extras above, and no batteries beside the seat.
  • TE20 (Continental): the Ferguson Club notes the Standard engine differed with an external oil filter and a Zenith carburettor, so the engine itself is the clue on an early tractor.

TE20 TEA20 TED20 difference in the body panels

For tinwork, the TE20 TEA20 TED20 difference is small. Parts catalogues list the main panels for the whole range. For example, Agriline lists one set of Ferguson footplates for the TE20, TEA20, TED20 and TEF20, as well as the FE35 and MF 35. Bare Co in Australia lists the TE20 grilles and side panels without splitting them by fuel. Yet there are a few places where the version matters, and the table shows them.

PanelTE20 and TEA20TED20TEF20 diesel
Bonnet top and side panelsSharedShared; the bonnet covers the dual tankShared in the catalogues we checked
Grille setSharedSharedShared in the catalogues we checked
Front T-barPetrol patternSame as petrolStarting handle hole is modified
Fuel tankSingle petrol tankTwo compartments: petrol and TVOSingle diesel tank
DashStandard dashWater temperature gauge addedCheck the gauge and switch holes
BatteriesNone beside the seatNone beside the seatTwo six volt batteries beside the seat
FootplatesSharedSharedShared (Agriline)
TE20 TEA20 TED20 difference by panel, with the TEF20.

The TEF20 diesel and the front T-bar

The one front panel that changes is the T-bar, the centre support between the two grilles. Its round hole lets the starting handle through. Bare Co lists its front T piece for the TE20 petrol and kerosene tractors, with the note that the starting hole must be modified for the TEF20 diesel. So on a TEF20 diesel, measure where the handle sits before you order a T-bar.

Ferguson TE20 front T-bar in red oxide with the round starting handle hole, the panel to check for the TE20 TEA20 TED20 difference
Our TE20 front T-bar. The round hole is for the starting handle.

The TED20 tank and the TEF20 batteries

On a TED20, the tank under the bonnet has two compartments, a small one for petrol and a larger one for TVO. The bonnet top is the same panel. Still, check that the old bonnet has not been cut or bent to clear a replacement tank. On a TEF20 diesel, the batteries sit beside the seat rather than under the bonnet. As a result, look at the panels around the seat and the rear mudguards for extra holes or brackets before you match new tinwork to them.

Which Ajva TE20 parts fit which version

We make nine TE20 body parts, and each product page lists it for the Ferguson TE20. The footplate is also listed by name for the TEA and TED. For the TEF20 diesel, send a photo of the front of the tractor before you order the T-bar, so we can check the starting handle hole.

Ferguson TE20 bonnet kit in red oxide with louvred grilles: no TE20 TEA20 TED20 difference in this panel
Our TE20 bonnet kit, painted in red oxide.

What to send with a TE20 parts enquiry

A good enquiry saves a round of emails. Before you write, take these from the tractor:

  1. The code and number from the serial plate, such as TED or TEF.
  2. A photo of the front, with the starting handle hole in view.
  3. A photo of the dash, if you also need panels near the gauges.
  4. The side you need, left, right or both, for side panels and mudguards.
  5. The quantity of each part. Our minimum is 5 pieces per product.

TE20 tinwork from Ajva Motors

We make aftermarket sheet metal body parts at our factory in Gujarat, India, and have done since 1998. Our TE20 panels are pressed from steel sheet and painted in red oxide or grey oxide. We send a sample on request, and we reply to quotes within 24 to 48 hours on business days.

See every part for this tractor on the Ferguson TE20 parts page. For panels across all models, see our tractor front grilles and tractor footplates. Our Ferguson TE20 bonnet kit guide covers the front end in detail. If you also restore the later tractor, read how to identify a Massey Ferguson 35.

TE20 TEA20 TED20 difference: common questions

Is a TEA20 the same tractor as a TE20?

It shares the body panels, but the engine differs. TE20 is the family name and also the code of the first tractors with the Continental engine. The TEA20 has the Standard petrol engine. The bonnet, grille and footplates are listed for both.

What is the TED20?

It is the TVO version, built from 1949. It starts on petrol and runs on tractor vaporising oil once warm. For that reason it has a tank with two compartments and a three way fuel tap.

Does a TED20 need a different bonnet?

Not in the catalogues we checked. The dual tank sits under the same hinged bonnet. Check that the old bonnet has not been cut, and send us a photo if it has.

Does the TEF20 diesel take the same front T-bar?

It is the same part, but the starting handle hole differs. A parts list from Bare Co says the petrol T piece needs its hole modified for the TEF20. Send a photo of your front end so we can check.

Where is the serial plate on a TE20?

On the instrument console, in front of the driver. Its position varies by model. The letters before the number give the code.

Not sure of the TE20 TEA20 TED20 difference on your own tractor? Send your panel list and photos through our contact page, and we will confirm each part before you order.

Ferguson TE20 Body Parts Ferguson TE20 bonnet kits and body panels, made and exported by Ajva Motors.
View Catalog →

AJVA Motors

Tractor Body Parts Manufacturer & Exporter